Flower pot and saucer

An impressive spiral shelter for green plants. The pot in the picture can hold an 18 cm wide clay pot. There are holes in the bottom of the pot, allowing excess water to drain into the saucer. Printed products are slightly porous, so if you use the pot directly on multicrops, the surface may darken over time.

 

You can see the colour options in the videos. The pot in the picture is printed on a matte purple-green filament.

PLA is made from plant-based biodegradable materials (mainly maize). It cannot withstand hot temperatures, but starts to soften at around 60 degrees Celsius.

 

Treatment:

• Each product is printed for you on order. Minor errors may occur because the product was printed on a home printer, not an industrial printer.
• Treat the product as a handmade product. This product is not moulded, but printed layer by layer.
• The product may be damaged if dropped on the floor.