Llama craft cutter

Llama craft cutter set. The set includes two llamas facing in different directions.

Shown are sizes 1 and 2. Thickness of the claysheet is 2.5 mm. The patterns of the copper-coloured lama are made with a snowflake texture roller. The cutter has a lot of small nooks and crannies, and the clay sticks to them easily. You can prevent sticking by using, for example, an cling film between the cutter and the clay.

Cutter sizes measured from the inside, width x height:

1: 15 x 26 mm

2: 18 x 30 mm

3: 21 x 35 mm

4: 24 x 40 mm

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.