Cat on the moon - polymer clay cutter

A cat on the moon. This cutter has two in one. You can use either the cut inside or the leftover outside.

The diameter of the circle is 3,6 cm. By using a 4 cm diameter circle cutter, you can make a spectacular piece of jewellery. Cut the inside and outside from different coloured masses and join them together, you get a nice two-coloured piece of jewellery.

 

Size 1: single cat looking left

Size 2: a pair of cutters with the cats facing opposite directions

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.