English Springer Spaniel earring pair (2)

This cutter is a silhouette of an English springer spaniel. When cutting with the cutter, be especially careful with your feet, as the hind legs can easily get caught in the cutter.

Kuvissa on käytetty kokoja 1 ja 2 ja massalevy ja leikkurin välissä elmukelmun palaa.

 

Cut the pulp sheet, which is slightly cool. You can use e.g. maize flour or potato flour, dip the cutter in flour, tap off the excess and cut the dog silhouette from the sheet.

Tässä korvakoruparissa on Englanninspringerspanielin leikkuri ja sille peilikuva, jotta saat molempiin korviin samaan suuntaan katsovan koiran silhuetin.

 

Cutter sizes measured from the inside, height x width

1: 2.3 x 3 cm

2: 2,7 x 3,5 cm

3: 3.1 x 4 cm

4: 3,4 x 4,5 cm

5: 3,8 x 5 cm

6: 4,2 x 5,5 cm

7: 4,6 x 6 cm

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.