3-dimensional bow tie, long ribbon, large

3-dimensional bow tie claycutter. Set includes three cutters, one collar, one ribbon and one foldable bow.

You can fold the ends of the bow in opposite directions, either to the back or to the front, with a narrow strip of ribbon to hide the seam from view. If you use a patterned bow tie, note the direction of folding.

The thickness of the bow varies. Size 1 is the narrowest, size 3 the thickest. The width and height of the whole bow is the same in all of them.

Height about 9 cm, width about 5 cm

1: 25 mm

2: 30 mm

3: 35 mm

 

If you order the whole set, it includes 3 different width bow cutters, the corresponding belts and ONE bow long ribbon cutter (the part with the green paste in the picture).

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.