Texture rolling pin "fish scales"

Fish scales, mermaid tails... A scaly texture for your texture-carving adventure.

Use a rolling pin to gently roll over the clay. If the clay is soft, it may stick to the grooves of the roller.

The roller is 10 cm long and about 2.3 cm thick

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean after use, remove the stuck clay with another piece of clay. You can also use potato flour between the sheet of polymer clay and the rolling pin when rolling.