Gingerbread droplet cutter

A gingerbread drop, or the other way round, a bird finch. Many different sizes, many different possibilities. These can be stacked on top of each other, of the same size or scaled down.

In the picture is size 1 and the pattern is made with a leather pattern roller.

Cutter height:

1: 25 mm

2: 30 mm

3: 35 mm

4: 40 mm

5 :45 mm

6: 50 mm

7: 55 mm

8: 60 mm

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.