Fox head clay cutter + stamp

A fox head crafting clay cutter. This cutter has a separate stamp, so you can make just fox-head shapes, or press the outline into the clay first and use the cutter to cut a pattern out of the clay sheet.

The cutter and the stamp are nested, for best results you can cut a head-shaped piece first and then stamp it, or stamp first and then cut.

Cutter sizes measured from the inside, width x height:

1: 2,5 x 2,5 cm

2: 3 x 3 cm

3: 3,5 x 3,5 cm

4: 4 x 4 cm

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.