Face stamp (round)

Four different sizes of face masks. These can make spectacular earrings, necklaces or even a keyring ornament. You can cut the patterns out of the clay with your choice of pattern cutter.

 

Height of the face

1: 3 cm

2: 3 cm

3: 3.5 cm

4: 4 cm

 

The stamps are very detailed, so it's best to press the stamp into cool paste so it doesn't stick to the stamp. Or you can use corn flour or potato flour to help, under the stamp.

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.