Suipompi simpukan muotoinen askartelumassaleikkuri

Suipompi simpukan muotoinen leikkurisetti. Leikkurissa on kuviopinta, joka tulee parhaiten esille 3 mm paksun massalevyn kanssa. Tällöin kuvio painautuu 1 millimetrin verran massaan. Kuvissa 2 cm ja 3 cm leikkureilla leikatut kuviot.

 

 

Cutter sizes measured from the inside, height:

1: 2 cm

2: 2.5 cm

3: 3 cm

4: 3.5 cm

5: 4 cm

6: 4.5 cm

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.