Peach cutter

Peach and peach leaf cutters. This is a pair of earrings, different you get two peaches and two leaves. The leaf cutter is integral to the peach cutter, so you don't lose it.

 

The joint height of the two cutters:

1: 20 mm

2: 25 mm

3: 350 mm

4: 35 mm

5: 40 mm

6: 45 mm

7: 50 mm

8: 55 mm

9: 60 mm

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.