Narrow roll, drops

3D printed texture roll, dripping drops. The roll pattern is 17 cm long.

Use a rolling pin to gently roll over the polymer clay. You can also use the rolling pin with a handle. This makes it easier to align if you want to make a pattern along a line.

You can either use a narrow handle that holds one roll, or if you want to make different combinations, you can put three rolls next to each other on a larger handle.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The craft rolls are printed in Finland, from plant-based, biodegradable plastic. The product must not be heated or put in the oven, it starts to soften at around 60 degrees Celsius.

Clean after use, remove the stuck clay with another piece of clay. You can also use potato flour between the sheet of polymer clay and the rolling pin when rolling.