Mermaid craft cutter pair

Mermaid earring pair. Round model, set with two cutters (mirror images). The mermaid clipper has thin sections, especially in the hair. Please take this into account when using especially smaller cutters.

The picture shows size 1. The thickness of the ground sheet is 2,5 mm and the pattern is cut through the elastic band.

 

Cutter width:

1: 30 mm

2: 35 mm

3: 40 mm

4: 45 mm

5: 50 mm

6: 55 mm

7: 60 mm

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.