Mäyrä askartelumassaleikkuri

Mäyrää ei näe juuri koskaan luonnossa. Mäyrä -korvakoruilla muistutat itseäsi ja kanssaeläjiä tästä mielenkiinoisesta eläimestä.

 

It is a good idea to use, for example, cling film or potato flour in between, so that the clay sheet does not stick to the cutter. Size 1 is used in the pictures.

 

Leikkurien koot sisäpuolelta mitattuna (mm):

1: 20 x 23

2: 25 x 28

3: 30 x 34

4: 35 x 39

5: 40 x 45

6: 45 x 51

7: 50 x 56

8: 55 x 62

9: 60 x 68

 

The cutter has a patterned surface that works best with a 3 mm thick ground sheet. In this case, the pattern is pressed into the clay by about a millimetre.

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.