Wide leaf craft cutter

A wide, leaf-shaped craft cutter that looks a bit like a Monstera leaf. This leaf is made so that both sides are identical. So you don't need a mirror cutter for the earrings.
A small leaf can be used to cut leaves for a doll's house flower, while the larger one can be used to make a beautiful earring or a chunky necklace.

Cutter height:

1: 25 mm

2: 30 mm

3: 35 mm

4: 40 mm

5 :45 mm

6: 50 mm

7: 55 mm

8: 60 mm

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.