Flipflop summer sandals (floral pattern) craft mass cutters

Läpsyt, sandaalit, flip-flopit. Leikkuriparissa on molemmat läpsyt, samaa kokoa. Näissä läpsyissä on varpaiden välissä kukkakuvio.

 

Cutter sizes measured from the inside, height:

1: 2,5 cm

2: 3 cm

3: 3.5 cm

4: 4 cm

5: 4,5 cm

6: 5 cm

 

Leikkurissa on kuviopinta, joka tulee parhaiten esille 2,5mm paksun massalevyn kanssa. Tällöin kuvio painautuu 1 millimetrin verran massaan.

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.