Skull and crossbones clay cutter set, with a bow

A skull with a bow on top, a cutter set, a stamp and a cutter for the outer edges. The picture shows the smallest size.

5 different sizes. Cutting with this requires care, especially with the smallest stamps. The shinbones easily stick to the clay. Do not press too hard.

For example, you can dip the cutter in cornflour first, knocking off the excess on the table before cutting the clay.

 

Cutter width x height:

1: 3 x 2,4 cm

2: 3,5 x 2,8 cm

3: 4 x 3,2 cm

4: 4,5 x 3,6 cm

5: 5 x 4 cm

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.