Lips clay cutter. For earrings, necklaces, card making.... There are plenty of uses. The set comes in 7 different sizes! In the picture are sizes 1 and 3.
Cutter sizes measured from the inside, width:
1: 2 cm
2: 2.5 cm
3: 3 cm
4: 3.5 cm
5: 4 cm
6: 4.5 cm
7: 5 cm
The cutter has a patterned surface, which is best used with a 2.5mm thick polymer clay. In this case, the pattern is pressed into the clay by 1 mm. For fuller lips, use a piece of cling film between the cutter and the clay.
The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.
For a short article on using a PLA polymer clay cutter, see the blog:
https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html
The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.
Clean the cutter after use, wipe off any visible clay.
Reviews
There are no reviews yet.