Knot in a basket craft cutter

Solmu askartelumassaleikkuri. Tässä leikkurissa on urakuviot ja keskellä on aukko. Saatavilla on viisi eri kokoa.

 

Ison leikkurin korkeus sisältä mitattuna:

1: 2 cm

2: 3 cm

3: 4 cm

4: 5 cm

5: 6 cm

 

The cutter has a patterned surface, which is best used with a 2.5 mm thick ground sheet. In this case, the pattern is pressed into the clay by 1 mm.

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.