Texture school "six" for a crafting adventure

3D tulostettu tekstuurikaulin. Pienet ja sirot kuuset tekevät todella kauniin tekstuuripinnan. Kuusen korkeus n. 1.2 cm. Kuvissa käytetty pyöreää leikkuria jonka halkaisija on 3.5 cm.

Use a rolling pin to gently roll over the clay.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean after use, remove the stuck clay with another piece of clay. You can also use potato flour between the sheet of polymer clay and the rolling pin when rolling.