Swing chain craft cutter pair

Haluatko tehdä punotun kaulaketjun tai korvakorut, mutta lenkkien teko askartelumassasta on hankalaa? Nappaa tästä lenkkileikkuri. Mukana on umpinainen lenkkileikkuri ja avoin lenkkileikkuri. Kuvissa on käytetty massaa, jonka paksuus on 2 mm.

Jos liität lenkit toisiinsa vasta paiston jälkeen, tee se mahdollisimman nopeasti kun lenkit ovat vielä hieman joustavia.

Lenkin korkeus:

1: 15 mm

2: 20 mm

3: 25 mm

4: 30 mm

5: 35 mm

6: 40 mm

7: 45 mm

8: 50 mm

9: 55 mm

10: 60 mm

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.