Orange wedge clay cutter

A clay cutter in the shape of an orange block. Or even a thick red pizza slice for Barbie's table.

This differs from the Art Deco -sarjan viuhkasta niin, että viuhkan ”luut” jatkuvat sisäkulmaan asti. Art Decon viuhkassa on pieni pyöristys sisänurkassa.

The length of the side of the fan is 2.5 cm.

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.