Plastic headband

A headband that can be covered with fabric, knitwear, just about anything.

This one has no spikes underneath, so it doesn't hold the hair but slides out of place. This is intended to be coated.

 

There are holes at the bottom for easy attachment of the top, and the wide arch has slots to both lighten the weight and provide breathability.

 

Dimensions:

arch size length: 36,5 cm

width of the arch at the bottom: 1 cm

width of the arch at the top: 4 cm

height 14 cm

weight approx. 20 g

 

The product will not fit in an xxs letter because of the width, always choose a package from the delivery options!

 

You can adjust the width of the pan with boiling water:

Take a large enough saucepan in which to boil the water. When the water boils, dip the other side of the pan into the water, about 1-2 seconds at a time. Repeat 2-3 times, and after each time, gently try to bend the pan into the desired shape. Repeat for the other side. You can also use a mould that you press the pan around after the pan has been poured, e.g. a hat. In this case you can dip both tips into the water, holding onto the top edge of the pan.

 

REMEMBER!

Boiling water is hot, the water droplets on the surface of the pan are hot, but the pan itself will not get too hot if you only use it for a short time. If you leave the pan in the water, it will soften and melt in the pan

This is printed in Finland, from plant-based, biodegradable plastic. The pan must not be heated, for example with a hairdryer while it is on. PLA plastic starts to soften at around 60 degrees Celsius.