A cog for card making (2.5 cm)

3D printed cogs are great for card making, decorating a bujo or even decorating Steampunk accessories.

The set includes four different cogs , all the same size (2 of each). Diameter 2.5 cm, thickness 2 mm. Diameter is measured to the outer edge of the rim, this is where the differently sized spikes / spikes come in.

 

1: short spikes

2: medium spikes

3: long spikes

 

Kuvissa akryylimaalattuja rattaita, viimeisenä spraymaalilla maalattu tuote. Kaikkien materiaalina sama harmaa PLA-muovi.

 

The material is PLA plastic, which can be painted with ordinary acrylic paints, or spray paint. You should apply several thin coats of acrylic paint, allowing the coats to dry, so that you get an opaque finish. If the paint doesn't stick, you should wash the wheel, for example with dishwashing liquid, to remove any grease that may have stuck to the surface from your fingers.

You can gently sand the painted surface with sandpaper to bring out the lower layers, or even right up to the print surface to bring out the grayish tint.

 

Cogs are printed in Finland, from plant-based, biodegradable plastic. The product is durable for decorative use, it is not a real durable cog.