Piparkakkureunainen pisara

Piparkakkureunainen pisara, tai toisinpäin katsottuna räpylä. Monta eri kokoa, monta erilaista mahdollisuutta. Näitä voi kerrostaa päällekkäin, samankokoisia tai suurentuen alaspäin.

Kuvassa koko 1. kuvio tehty nahka kuviorullalla. 

 

Cutter height:

1: 25 mm

2: 30 mm

3: 35 mm

4: 40 mm

5 :45 mm

6: 50 mm

7: 55 mm

8: 60 mm

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.