Päivänkakkara askartelumassaleikkuri

Tällä leikkurilla teet päivänkakkaraa muistuttavat kukat askartelumassasta. Tällä voit tehdä myös auringonkukkia!

 

The cutter has a patterned surface that works best with a 3 mm thick ground sheet. In this case, the pattern is pressed into the clay by about a millimetre.

 

Cutter sizes measured from the inside, width:

1: 2 cm

2: 2,5 cm

3: 3 cm

4: 3,5 cm

5: 4 cm

6: 4,5 cm

 

The cutter needs a little more pressure than a metal cutter. The cutting edges will be sharp and precise. You can also use cling film or a piece of plastic bag in between the cutter and the polymer clay, if you want rounder edges.

 

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

 

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean the cutter after use, wipe off any visible clay.