Daisy (solid)

Daisy polymer clay cutter. This cutter leaves an indentation in the center, and the edges of the center are not round but slightly jagged. The same cutter also makes a hole in the center. You can find it here.

Size 1 is made with a solid cutter and size 5 is made with a cutter that leaves a hole in the center of the flower.

Cutter diameter:

1: 20 mm

2: 25 mm

3: 30 mm

4: 35 mm

5 :40 mm

6: 45 mm

7: 50 mm

8: 55 mm

9: 60 mm

You need to press down a little harder than with a metal cutter. The cut edges will be sharp and precise. You can also use cling film or a piece of plastic bag if you want the edges to be rounder.

A short article on the use of PLA plastic polymer clay cutters can be found on the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland from plant-based, biodegradable plastic. The product must not be heated or placed in the oven, as it begins to soften at a temperature of around 60 degrees Celsius.

Clean the cutter after use, removing any visible residue by wiping it off.