Tassu askartelumassaleikkuri negatiivi

Tassun muotoinen leikkuri. Tässä leikkurissa anturat painautuvat massaan. Kuvassa koko 1. Saat tassuista pulskempia, kun käytät leikkurin alla kelmua.

Muottien koot sisäpuolelta mitattuna, korkeus:

1: 2 cm

2: 2,5 cm

3: 3 cm

4: 3,5 cm

5: 4 cm

6: 4,5 cm

Leikkurissa on kuviopinta, joka tulee parhaiten esille 2,5 mm paksun massalevyn kanssa. Tällöin kuvio painautuu noin millimetrin verran massaan.

You need to press down a little harder than with a metal cutter. The cut edges will be sharp and precise. You can also use cling film or a piece of plastic bag if you want the edges to be rounder.

A short article on the use of PLA plastic polymer clay cutters can be found on the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland from plant-based, biodegradable plastic. The product must not be heated or placed in the oven, as it begins to soften at a temperature of around 60 degrees Celsius.

Clean the cutter after use, removing any visible residue by wiping it off.