Papukaija askartelumassaleikkuri

Papukaijakorvakorut, papukaija kaulakoru… Voisiko tällä tehdä myös papukaija rannekorun? Settiin kuuluu kaksi papukaijaa, jotka ovat toistensa peilikuvat. Katsooko papukaija korvassa eteen- vai taaksepäin? Siinäpä pulma ratkaistavaksi

Kuvissa koot 1 ja 2, askartelumassan paksuus 3 mm.

Muottien koot sisäpuolelta mitattuna, leveys x korkeus (mm):

1: 26 x 39

2: 30 x 45

3: 35 x 53

4: 40 x 61

5: 45 x 68

6: 50 x 76

You need to press down a little harder than with a metal cutter. The cut edges will be sharp and precise. You can also use cling film or a piece of plastic bag if you want the edges to be rounder.

A short article on the use of PLA plastic polymer clay cutters can be found on the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland from plant-based, biodegradable plastic. The product must not be heated or placed in the oven, as it begins to soften at a temperature of around 60 degrees Celsius.

Clean the cutter after use, removing any visible residue by wiping it off.