Art Deco roll, leaves

3D printed texture roller. Art Deco leaf. Pattern length is 17 cm

Use a rolling pin to gently roll over the polymer clay. You can also use the rolling pin with a handle. This makes it easier to align if you want to make a pattern along a line.

You can either use a narrow handle that holds one roll, or if you want to make different combinations, you can put three rolls next to each other on a larger handle.

For a short article on using a PLA polymer clay cutter, see the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland, from plant-based, biodegradable plastic. The cutter must not be heated or put in the oven. The cutter starts to soften at around 60 degrees Celsius.

Clean after use, remove the stuck clay with another piece of clay. You can also use potato flour between the sheet of polymer clay and the rolling pin when rolling.