Tyylitelty A askartelumassaleikkuri

Kaari, A, ehkä jotain muutakin näet tässä leikkurissa?

Yksi koko, korvakorupari. Kuvassa käytetty lumihiutale-kuviokaulinta massan pintaan ja sen jälkeen leikattu korun osat irti massalevystä.

Leikkurin koko: 3,2 x 4,4 cm

You need to press down a little harder than with a metal cutter. The cut edges will be sharp and precise. You can also use cling film or a piece of plastic bag if you want the edges to be rounder.

A short article on the use of PLA plastic polymer clay cutters can be found on the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland from plant-based, biodegradable plastic. The product must not be heated or placed in the oven, as it begins to soften at a temperature of around 60 degrees Celsius.

Clean the cutter after use, removing any visible residue by wiping it off.