Simpukka jonka sisällä on helmi -askartelumassaleikkuri

Klassinen simpukka ja helmi leikkuri.

Leikkurissa on kuviopinta, joka tulee parhaiten esille 3 mm paksun massalevyn kanssa. Tällöin kuvio painautuu 1 millimetrin verran massaan. Kuvissa koot 1-3.

Muottien koot sisäpuolelta mitattuna, leveys x korkeus:

1: 2 x 2,3 cm

2: 2,5 x 3 cm

3: 3 x 3,4 cm

4: 3,5 x 4 cm

5: 4 x 4,6 cm

6: 4,5 x 5,2 cm

7: 5 x 5,7 cm

You need to press down a little harder than with a metal cutter. The cut edges will be sharp and precise. You can also use cling film or a piece of plastic bag if you want the edges to be rounder.

A short article on the use of PLA plastic polymer clay cutters can be found on the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland from plant-based, biodegradable plastic. The product must not be heated or placed in the oven, as it begins to soften at a temperature of around 60 degrees Celsius.

Clean the cutter after use, removing any visible residue by wiping it off.