Mansikka askartelumassaleikkuri (irtokanta)

Herkullinen mansikka askartelumassaleikkuri. Älä kuitenkaan poimi oransseja mansikoita syötäväksi, ne ei ole parhaimman makuisia!

Settiin kuuluu mansikkaleikkuri ja erillinen irtokantaleikkuri. Voit asetella kannan mansikan päälle tai vaikka renkaalla yläpuolelle.

Mansikan korkeus

1: 20 mm

2: 25 mm

3: 30 mm

4: 35 mm

5: 40 mm

6: 45 mm

7: 50 mm

8: 70 mm

You need to press down a little harder than with a metal cutter. The cut edges will be sharp and precise. You can also use cling film or a piece of plastic bag if you want the edges to be rounder.

A short article on the use of PLA plastic polymer clay cutters can be found on the blog:

https://www.johannas3d.com/2022/10/re-post-askartelumassaleikkureita.html

The polymer clay cutters are printed in Finland from plant-based, biodegradable plastic. The product must not be heated or placed in the oven, as it begins to soften at a temperature of around 60 degrees Celsius.

Clean the cutter after use, removing any visible residue by wiping it off.