Stoppers for knitting barber cords (dual head)

Do you use knitting barber cords? Do you tie a knot in the end to prevent the slipping of the stitches?

Worry no more! There's no need to break the ends of the cords with knots when you use these simple stoppers. Dual head stopper is good when you knit in a round and need to keep the cord ends next to each other. If you need a pair of the cord stoppers, you can find them here.

This does not pinch the cable like cord tighteners do. Thread the cable ends through the holes in the inside of the stopper upwards and down along the curve through the hole on the outer edge. The cable stays in place well with a slight tightening.

Choose the size depending on your cable thickness. Easiest way to measure the thickness is to use a needle gauge.

Sizes:

1: 2.0-2.2 mm

2: 2.4-2.6 mm

3: 4.0-4.2 mm

Stoppers are printed from biodegradable plant-based PLA plastic. PLA does not withstand temperatures above 60 degrees Celsius, steam irons, or other hot items.